- Used to raise Alkalinity Levels in Swimming Pools
- Prevents pH Bounce and helps maintain pH levels
- Fast Dissolving Granules
- Next Day Delivery
DELIVERY: Fi-Clor Alkalinity Increaser is sent out on a next working day service but all standard deliveries will be within 5 working days
RETURNS: Fi-Clor Alkalinity Increaser can be returned to us, in compliance with the Consumer Contracts Regulations, unused and in their original packaging, suitable for resale, within 14 days from date of delivery. Returns should always be sent via "Signed For" carrier or postal service.
Our returns address is Giraffe Enterprises Ltd, Bexley Garden Centre, 57 North Cray Road, Sidcup, Kent. DA14 5EU. Tel: 01322 554 870
When a return is received back into our warehouse our returns department confirm that everything is present and that the item is in its original condition, to make sure it is eligible for a refund. We will process the refund normally on the same day we take them in, but please allow up to a maximum of 14 working days for the money to reach your bank or credit card. It is unlikely to take this long but due to reasons such as bank delays or errors, this may occasionally occur.
PRODUCT INFO: Fi-Clor Alkalinity Increaser is used for raising the Alkalinty levels in your swimming pool. Maintaining the correct Alaklinity levels in the swiming pool water is important as low Total Alkalinity levels may cause any chemicals added to the water to alter the pH level.
Total Alkalinity is the measure of carbonates & bicarbonates in the water. Ensuring it is correct will reduce pH fluctuations.
Instructions To Correct Low Alkalinty Levels in Swimming Pools & Hot Tub Spas using Fi-Clor Alkalinity Increaser
Calculate your pool or spa water volume, if in doubt use this link to our Swimming Pool Chemical Handbook to use the handy swimming pool volume calculator
Test your water using your prefered testing method. If lower than 100ppm you will need to raise it
Dissolve the amount suggested on the label of Fi-Clor Alkalinty Increaser in a 10 litre bucket. Do not dissolve more than 500g at any one time. If more than 500g is required repeat the process.
With the pumps running pour the mixture evenly around the pool, but not into the skimmers.
Leave the filtration running and re-check the Alkalinity levels after 24 hours. If the level is still low re-dose with Fi-Clor Alkalinity Increaser until the level is correct.